3 - CONTROLS/INSTRUMENTS
RIGHT-HAND SIDE CONTROLS
Right-hand control arm
4519A5C4
1
1. Ignition switch
This switch has four positions,
“On”
(contact),
“Start”
(engine ignition),
“Off”
(engine shut-down) and
“Acc”
(accessory current supply).
NOTICE:
When the ignition key is in
“On”
(contact)
position, if the anti-theft protection has been pro-
grammed, then it will be necessary to enter the code.
The message "Password" will be displayed. (Refer to
page
4-4
).
NOTE:
This key is also used to lock the cab door, the
engine hood, the front storage compartment, the side
doors and the fuel tank cap.
2. Engine acceleration button and working mode selec-
tor
This button enables an increase or reduction in the
engine speed.
This button is coupled with the three working mode
selector.
Mode
“A”
(automatic) when the energy output has
priority.
In this mode, the balance between the speed and en-
ergy output is controlled for each movement of the
controls.
Mode
“H”
for difficult excavation work or if the load in-
creases, and mode
“SP”
when the output has priority.
Each selected mode
(A
,
H
or
SP)
is displayed on the
screen.
NOTE:
To select the
“SP”
mode, operate the indexing
pin while rotating the acceleration button to the right.
NOTE:
If there is no change in engine speed, press
and release the engine automatic idle speed selector.
3. Engine idle speed selector
This control enables automatic engine idle without op-
erating the throttle button.
To select idle speed, press and release the control for
the engine automatically to go into idle speed; the "En-
gine idling" icon will appear on the message screens.
When the control is pressed and released once more
the engine will revert to its original speed and the icon
on the systems display panel will disappear.
4. Travel caution alarm switch
“Cont”
position the alarm sounds when the travel con-
trols are actuated.
“Auto off”
position, when the travel control are actu-
ated, the alarm sounds for 10 seconds and then stop.
5. Option control (if equipped)
6. Cab radio
To operate the cab radio. (Refer to page
3-60
7. Wiper switch
When the switch is pressed, the wiper moves.
8. Radio auxiliary input port
This radio provided auxiliary input jack so that portable
audio products can be connected.
3-58
Summary of Contents for CX145C SR
