Case 580ST, Operator'S Manual

Page: 425 / 434

10 - ACCESSORIES
Manual auxiliary hydraulic tools
WARNING
Equipment failure could cause accident or injury!
Use only authorized auxiliary hydraulic attachments. Always read and understand the manual or in-
structions supplied by the manufacturer to avoid injury or damage. Understand the operation and
safety instructions before you attach, remove, or operate the attachment.
Failure to comply could result in death or serious injury.
W0231A
Before using auxiliary tools (3) , it is mandatory to
proceed as follows:
1. Place the direction-of-travel control lever to neutral
position.
2. Place the gearshift lever in the neutral position.
3. Lower the loader attachment to the ground.
4. Apply the parking brake to prevent the machine from
moving.
5. Shut down the engine, release all pressure in the
auxiliary circuit.
6. Place the manual auxiliary hydraulic tool switch (1) in
the OFF position.
7. Stop the engine, remove the plugs and connect the
tool hoses to the couplings in front of the fuel tank.
Coupling
(3) is for the hydraulic oil supply line and
coupling (2) is for the hydraulic oil return line.
8. Start the engine and place the accelerator knob/lever
in full speed position.
9. Place the manual auxiliary hydraulic tool switch (1) in
the ON position (lamp on), now it is possible to use
the tool.
10. When the tool is no longer required, place the manual
auxiliary hydraulic tool switch (1) back to the OFF
position (lamp off).
LEEN11T0287BA
1
FLOW SELECTION
It is up to the operator to decide which flow should
be used by consulting the manufacturer’s operating
instructions. Make sure to respect the prescribed
delivery. Excess flow can damage some equipment.
1. If necessary, adjust the flow regulator on the chassis
in front of the rear axle. Consult your Dealer for assis-
tance.
LEEN11T0288AA
2
10-5