Cascade Sciences CVO-2-HT, Installation And Operation Manual

Page: 25 / 72

25 | P a g e
cascadesciences.com | Tel. 503 847-9047
INSTALLATION
P
OWER
S
OURCE
R
EQUIREMENTS
When selecting a location for the unit, verify each of the following requirements is satisfied.
Power Source : The wall power outlet must meet the power requirements listed on the unit data
plate.
Model AC Voltage Amperage Frequency
CVO-2-HT
110 – 120 10 50/60 Hz
CVO-5-HT
110 – 120 13 50/60 Hz
•
Wall power sources must be protective earth grounded and single phase .
•
Wall power sources must conform to all national and local electrical codes.
•
Supplied voltage must not vary more than 10% from the data plate rating . Damage to the unit
may result if the supplied voltage varies more than 10%.
•
The recommended wall circuit breakers for these units are 15 amps.
•
Use a separate circuit to prevent loss of product due to overloading or circuit failure. The circuit
must match or exceed the amperage requirement listed on the unit data plate.
Power Cord : The unit must be positioned so that all end-users can quickly unplug the oven in the
event of an emergency.
•
The unit comes provided with a 125 volt, 15 amp, 9ft 5 in (2.86m) NEMA 5-15P power cord.
Fuses: These units each ship with a 16 amp 250V 5x20mm fuse installed in a fuse holder
immediately adjacent to the power cord inlet.
•
The fuse must be installed and intact for the unit to operate.
•
Always find and fix the cause of a blown fuse prior to putting the unit back into operation.
Standard 15-
amp NEMA
5-15 power
outlet.