5. ASSEMBLY
5-1 ASSEMBLY THE FOLDING HANDLE
A) Fix the lower handlebars into the unit
body with locking knobs as Fig. 2A,/Fig.2B/
Fig.2C shown.
B) Connect the upper handle and the lower
handle with the locking knob.
(Fig.2D/Fig.2E/Fig.2F)
C).Attach the cable clamp to the position
shown and then attach the cable (Fig.2G)
5-2 ASSEMBLY THE GRASS CATCHER
1. To fit: Raise the rear cover and hitch the
grass catcher on rear of mower. (Fig.3A/
Fig.3B/Fig.3C)
2. To remove: grasp and lift the rear cover,
remove grass catcher.
There is a level indicator on the top of the
grass catcher that shows whether the
catcher is empty or full :
- The level indicator inflates if the catcher
is not full during the moving. (Fig. 3E)
- If the catcher is full, the indicator co
lapses; once this happens, stop moving
immediately and empty the catcher,
make sure it is clean and ensure its
meshwork is ventilated. (Fig. 3D)
IMPORTANT:
If the position of indicator opening is very
dirty, the indicator will not inflate-in this
case, clean the position of indicator opening
immediately.
6. ADJUSTMENT OF CUTTING HEIGHT
Apply outward pressure to disengage lever
from rack. Move lever forward or back to
adjust height.
The height (the blade to the ground) can be
adjusted from 20mm (position 1) to 70mm
(position 6), 6 height positions. All wheels
will be in the same height of cut.
Fig. 2D
Fig. 2G
Fig. 2A
Fig. 3A
Fig. 2E
Fig. 2B
Fig. 3B
Fig. 2C
Fig. 3C
Fig. 2F
Fig. 3D
Fig. 3D
Fig. 3E
Fig. 3E
