- Dismount the unit following the steps on moun-
ting but afterwards.
- Ensure cables are not trapped when stroing.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.
If any anomaly is detected, check the following table.
No deter-
gent suction
Units with tanks
Lance nozzle is not in ow
pressure mode
Slide lance nozzle into low pressu-
re position
High pressure extension
hose or high pressure hose is
too long
Remove high pressure extension
hose shorter than 7,5 m
Injector is clogged on pump
Bring the appliance to any custo-
mer serrvice
Units with
attachable
applicators
Detergent applicator is
clogged
Clean applicator with warm water.
If it not works, replace the appli-
cator
Pressure washer does not
start up
Unit is pressurized
Squeeze trigger on gun
Plug is not well connected or
electric socket is faulty
Check plug, pocket and fuse
Extension cord is too long or
wire size too small
Remove extension cord
Main voltage supply is too
low
Check the voltage in the main
supply match the voltage indicated
on the Rating Label
Thermal safety switch has
tripped
Switch off unit and allow motor to
cool down
Pump does not reach the
necessary pressure
Water inlet filter is clogged
Clean water inlet filter
Pump is sucking air from
hose connections
Check that connections and loc-
king ring are properly tightened
Nozzle is worn or not correct
Bring the appliance to any custo-
mer service
Unloader is clogged or worn
Valves are clogged or worn
Fluctuating pressure
Pump is sucking air from
hose connections
Check that connections and loc-
king ring are properly tightened
Clogged nozzle
Clean the nozzle with the typ
cleaner.
Valves are dirty, worn or
stuck
Bring the appliance to any custo-
mer service
Water seals worn
