333
P
anama
®
H
alo
INSTALLATION INSTRUCTIONS
Unpacking:
Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts
listed here. Before discarding packaging material, be certain that all parts have been removed.
GETTING STARTED
CEILING hARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
FAN PREPARATION
Prepare for fan installation as follows:
Step A.
Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Step B.
Using the provided allen wrench, loosen the set
screw several turns to allow installation of the downrod.
Thread the downrod into the motor coupling until it stops
turning, this will take at least four and a half full turns.
Step C.
Securely tighten the set screw with the provided
allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the set screw
may cause the fan to separate from the
downrod during normal operation!
important safety information!
bEfOrE STArTIng THE InSTALLATIOn Of YOur CEILIng fAn,
InSTALL THE THrEADED DOwnrOD InTO THE mOTOr COuPLIng
AnD LOCK THE ASSEmbLY
AddITIonAl hARdwARE
2
1
/
4
” x 8-32 ROUND
HEAD SCREWS (2)
FLAT WASHER
(2)
1” x 8-32 ROUND
HEAD SCREWS (2)
perma•lock™ hardware
ALLEN SET
SCREW
1
¦
4
-20 x
1
¦
4
”
(pRE-INSTALLED)
3mm
ALLEN WRENCH
mOTOR
COUpLINg
TApERED
THREAD
MOTOR
WIRES
GROUND
WIRE
ALLEN
SET SCREW
DOWNROD
& BALL
ASSEMBLy
Tip:
The downrod has a tapered thread that is de-
signed to lock completely when correctly installed.
Carton Contents
The fan carton contains the fan body, warranty card, owner’s manual, and all the parts neccessary ( except blades) to assemble and install
your Casablanca ceiling fan. These parts are shown at the start of each installation section. before you start, go through thie Owner’s manulas
and confirm thaat you have all the parts shown in each section. Be Sure to use only genuine Casablanca blades, The blade shrink wrap holds 5
blades of matched weight. If more than one fan is being installed, be sure not to mix blade sets
Caution:
When removing the shrink wrap, be careful not to scratch the blades.
SUPPORT INSTALLATION
LAG SCREW
3/8”7 x 5”
LARGE FLAT
WASHER 3/8”
DOWNROD & BALL
ASSEMBLy
