j)
Install appropriate light bulbs(100W A19 Bulb). Do not
exceed the maximum wattage indicated on the light
fixture
k)
Align the three (3) indents in the glass with the three(3)
tabs in the shade holder and turn right(clockwise) until
the glass in locked in place
l)
Connect fob pull chains to light pull chain and fan pull
chain.
INSTALLING THE LIGHT FIXTURE
FAN WILL NOT START
Check main circuit fuses, circuit breakers, or wall switch position.
Check all wire connections, making sure the power is turned off during this inspection.
Check that reverse switch is not set in center of throw.
FAN WOBBLES OR
Be sure canopy pin is properly set into the slot on the ball.
SHAKES EXCESSIVELY
Check the screws holding the blade holders to the flywheel (or direct drive motor). Tighten as
necessary.
Check that bladeholders have not been bent during installation.
FAN NOISY DURING
Check and tighten light fixture retaining screws, glass shade screws and/or the light bulb(s) as
neccessary.
OPERATION
Tighten the blade to bladeholder screws.
Tighten canopy screws and mounting plate assembly.
Check and tighten blade holders to flywheel (or direct drive motor).
Make sure all screws in the motor housing are snug, but not overly tight.
Check that the wire nuts inside the canopy and switch housing are not touching the metal parts or
have fallen off the wire splices. Tighten or adjust as necessary.
BREAK-IN PERIOD
Let fan run at high speed for two (2) hours
DOES NOT RUN ON
If new, “break-in” may be required - run at higher speed for several days
LOW SPEED
For questions or to locate the nearest
Airflow Authorized Service Center
call toll free:
1-888-227-2178
BEFORE REQUESTING SERVICE:
Please follow this troubleshooting guide before contacting your dealer for assistance.
Caring for Finishes
: For cleaning, a soft brush or lint-free cloth
should be used to prevent scratching the finish. A vacuum cleaner
brush nozzle can remove heavier dust. Surface smudges or an ac-
cumulation of dirt and dust can easily be removed by using a mild
detergent and slightly dampened soft cloth. An antistatic agent may
be used, but
never
use abrasive cleaning agents. These will dam-
age the finish. Painted and high-gloss blades may be cleaned in the
same manner.
Blades
: Wood finish blades should be cleaned with a furniture
polishing cloth. Occasionally, a light coat of furniture polish may
be applied for added protection and beauty.
Never Lubricate this Fan!
The precision motor at the heart of your Airflow fan features sealed
bearings that are lubricated for life. Do not attempt to oil the mo-
tor.
Changing Light Bulbs
Be sure to turn power to the fan OFF at the wall switch or circuit
breaker before changing light bulbs. Replace bulbs with same type
as removed from the fixture. Each fan is rated for a
maximum
TOTAL
wattage of lighting.
Exceeding the rated maximum allowable wattage for the fan will
burn out the fan electronics module and void the warranty.
TROUBLESHOOTING
PROBLEM
POSSIBLE REMEDIES