2
Step 3.
Disconnect power to the ceiling fan and light kit at
the main electric panel. Remove fuse or move circuit breaker
to the OFF position.
Step 4.
IMPORTANT! Before installing this control, change
the factory default dip switch settings to your own unique
code. Be sure the dip switch positions of the transmitter and
receiver match, or the ceiling fan will not function. Select
different combinations of dip switches to prevent
misoperation due to other remote control fans, garage door
openers, etc.
Step 5a.
If you are installing the remote control with a new
fan installation, complete the fan installation according to
its instructions, up to the point of installing the Hang•Tru®
canopy.
Step 5b.
If the fan is already installed, reverse the installa-
tion procedure to remove the ceiling fan and Hang•Tru®
canopy from the Crossbar Mounting Bracket.
CONNECTING RECEIVER AND HOUSE WIRING
Step 6.
Use the 2 large wire nuts supplied to connect the
black and white wires on the top of the receiver to the house
wiring. Place each of the bare ends of wire next to each
other, then secure with a large wire nut. Test the connection
by pulling on the wire nut. (FIG. 2)
• The BLACK receiver wire connects to the BLACK HOT wire
in the ceiling outlet box.
• The WHITE receiver wire connects to the WHITE NEU-
TRAL wire in the ceiling outlet box.
Step 7.
Push the wire nuts through the center opening in
the Crossbar Mounting Bracket, so they will not interfere
with the canopy and receiver installation. Route the
house ground wire and the Crossbar Mounting Bracket
ground wire through the hole in the center of the
receiver. (FIG. 3)
INSTALLING RECEIVER IN THE CANOPY
Step 8.
Place the Adapt•Touch
TM
receiver in the Hang•Tru®
canopy with the receiver open side facing the canopy
opening. The receiver will align itself on the screw openings
in the bottom of the canopy.
Step 9.
Refer to the “Canopy Installation” section of the
ceiling fan manual for directions on installing the canopy
screws and lock washers. (FIG. 4)
Step 10.
Refer to the “Hanging the Fan” section of the
ceiling fan manual for directions on hanging the fan inside
the canopy. Note that the Blue wire of the fan should NOT
be capped, as the Adapt•Touch
TM
will use this wire for light
control.
NOTE:
Do not allow wires to be pinched between the
edge of the Crossbar Mounting Bracket and Receiver.
RECEIVER INSTALLATION PREPARATION
TIP:
When aligning the
canopy to the bracket,
install the canopy screw
through the canopy open-
ing first. Install the other
three canopy screws. Then
remove the canopy screw
for use in Step 14.
RECEIVER
TRANSMITTER
(BACK SIDE,
BATTERY HATCH REMOVED)
CANOPY
OPENING
GREEN
GROUND
WIRES
WHITE WIRE
BLUE WIRE
BLACK WIRE
ANTENNA
GREEN
GROUND
WIRES
WHITE WIRE
BLUE WIRE
BLACK WIRE
ANTENNA