M8505-01 • 11/21/12
M8505-01 • 11/21/12
1.888.830.1326
1.888.830.1326
6
7
After the light kit is mounted to the fan, feed
the pull chains from the fan’s switch housing
and the light kit through the grommeted
holes in the base of the light kit. Extension
chains are provided, if necessary. Both pull
chains must line up with the grommeted
holes to operate properly.
Grommeted
Hole
Pull Chain
Using the single pin connectors, connect
the black or blue wire from the fan to the
black wire from the light kit. Connect the
white wire from the fan to the white wire
from the light kit.
TYPE-B ASSEMBLY INSTRUCTIONS
TYPE-B ASSEMBLY INSTRUCTIONS (CONTINUED)
Lift the light kit assembly up so that the
screw holes in the lower switch housing
line up with the holes in the upper switch
housing. Install the switch housing
screws and tighten securely.
Feed the wires through the center hole in
the switch housing, the washer, and the nut.
Then install the switch housing by twisting
clockwise onto the threaded rod. Install
the washer and nut onto threaded rod and
tighten securely.
1
2
4
Wire
Connector
Switch
Housing
Switch
Housing
Screw
If your fan does not have pin connectors
on the wires coming from the switch
housing, install the wiring harness
provided. Using the provided wire
connectors connect the white wire from
the fan to the white wire from the wire
harness and connect the black or blue
wire from the fan to the black wire from
the wire harness.
Indentation
Tab
Installing the bulb - Install a bulb into each
of the sockets. When necessary, replace
with bulbs of the same type and wattage.
Socket
Installing the Pull chain pendant -
Attach the pull chain pendant to the
end of the short chains coming from the
switch housing and the light kit. Turn
power on. Your installation is complete.
5
7
6
8
Do not allow the light kit to hang
only by the wire connections!”
3
Installing the globe
(sold separately)- Position the
indentations in the outer rim of the globe so that they
line up with the tabs on the inside surface of the light
fixture rim. Carefully lift the globe up inside the light
fixture as far as it will go. Rotate the globe in a clockwise
direction until it is held tightly in place by the four tabs.
