4
ceIlInG hardware
CROSSBAR mOUNT-
INg BRACKET
Wire nut (4)
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked ‘
Approved for ceiling fan mounting
’. If it is
not, a new box must be installed.
warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
addiTional hardware
2
1
/
4
″
x 8-32 ROUND HEAD
screWs (2)
FLat Washer (2)
1
″
x 8-32 ROUND
head screWs (2)
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
crossbar mountInG bracket InstallatIon
CEILINg
wIRINg
CROSSBAR
mOUNTINg
BRACKET
FLAT
wASHER
gREEN
gROUND
wIRE
CEILINg FAN
approved
wIRINg BOX
RIDgE
SIDE
DOwN
canopY hardware
canopy
canopy
HATCH
canopy Lock Washer (4)
canopy screW (4)
approved
OUTLET BOX
HARDwARE
proceed with installation as follows:
Step 1.
Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the
bracket, with ground wire and ridges down, to the ceiling
fixture outlet box with the mounting hardware included with
the outlet box.
Tighten the screws firmly by
hand
only, being careful not to
bend the bracket by over tightening.
noTe:
The fan weight is 23 pounds.
