mOTOR
COUPLINg
TAPERED
THREAD
mOTOR
WIRES
gROUND
WIRE
Step E.
Using the provided allen wrench, loosen the allen
set screw. Thread the downrod into the motor coupling until
it stops turning, this will take at least four and a half full
turns.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the locking
bolt may cause the fan to fall during normal
operation!
imporTanT safeTy informaTion!
BEFORE STARTINg THE INSTALLATION OF yOUR CEILINg FAN, IN-
STALL THE THREADED DOWNROD INTO THE mOTOR COUPLINg AND
LOCK THE ASSEmBLy
ALLEN
SET SCREW
DOWNROD
&
BALL
ASSEmBLy
Prepare for fan installation as follows:
Step D.
Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly, keeping the wires
to one side of the cross pin.
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked ‘
Approved for ceiling fan mounting
’. If it is
not, a new box must be installed.
warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
noTe:
The fan weight is 35 pounds.
noTe:
The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
ALLEN SET SCREW
1
⁄
4
-20 x
1
⁄
4
”
(PRE-INSTALLED)
3mm
ALLEN WRENCH
FAN PREPARATION
GETTING STARTED
