5. Comparator Function - HI / LOW Limit Setting
①
Press the
key until the display s
"WL OFF". "WL OFF" means that compar
function is not activated.
hows
ator
②
Press
key to activate this function.
The display shows "WL ON".
③
Press
key once to set up the low
limit. The display shows "1.000" and the first
number flashes.
④
Press the
key to have number
increase. To move flash to next digit, press
the
key.
⑤
Press
key to set up HIGH limit. The
display shows "2.000" and you can change
these numbers by pressing
key.
If you want to move to next digit you can go by
pressing
key.
⑥
If you set up HIGH limit you can go out by
pressing
key, and "End" message on
the display.
⑦
If you set up HIGH limit and LOW limit
incorrectly, "Err" will be shown on the display.
Then you may need to set it up again. For
example, setting LOW LIMIT=2.990 kg and
HIGH LIMIT=1.990 kg this is incorrect setting
because HIGH limit is lower than the LOW
limit. When HIGH and LOW limit are set as the
same or above maximum capacity it still
shows "Err" message.
⑧
Suppose that the HIGH limit and LOW limit
are set up as 2.990kg and 1,990kg
respectively.
If the weight loaded is 2kg between HIGH and
LOW limit the display shows "OK" and the
10
