CAS CT100 Series, Service Manual, Page: 11 / 67

11
Chapter 2. Calibration
This chapter explains how to set in calibration mode.
To go to calibration mode, turn on the power while pressing the calibration switch.
Calibration mode is comprised of the following menus.
Table 1: Calibration Mode
Menus Description Remarks
CAL

Make calibration
save
EEPROM
SPAN

Make fine calibration
CSET1

Set part 1, such as lb/kg, capacity, e value,
dual/single, weight unit, maximum tare, initial
zero, and one-time tare/successive tare,
Minimum Weight Sale Enable/Disable,
Stable Sensitivity.
save
EEPROM
CSET2

Set part 2, such as digits, comma/dot, local
gravity, destination gravity, password, round
and print enable/disable.
save
EEPROM
MAC

Set MAC address (Ethernet version)
TEST

Test device’s status, such ad, span, display,
key, memory, print and battery
PLANT

Make factory setting, such as scale default set
and erase all data
A. CAL
①
Initial display in calibration mode.
②
Press key. You will see the “UnLoad” on the display.
Calibration Range A/D Value : (Load – Unload ) > 5000