CHANGE THE IR CODE
If your IR remote control shares common Phillips RC-50 codes with your other products, such as volume control, power,
etc., you can change the command codes in the IR remote and DMS-800PV as follows.
The default settings are IR Code A
(Blue Power LED).
To change, follow these steps.
1.
Select
IR Code
and
press
the
right arrow key
.
2.
Highlight
IR Code A
(Red Power LED) and
press
Enter
on the IR remote.
You will notice the IR remote no longer works after change the setting in the DMS-800PV. You now need to match the IR
remote codes to the same IR Code set of the DMS.
Press and hold
the
Menu
button
on the IR remote for
5 seconds
until the Power button
flashes RED
. Now the DMS and IR
remote control IR Codes will match with the DMS and should not interfere with your other electronics. To switch back,
simple repeat processes in steps 1-3 to IR Code A (Blue Power LED). Resetting the DMS-800PV defaults back to Code A/Blue.
FACTORY RESET
This Resets the DMS-800PV to factory default. If at any time the DMS-800PV is not functioning normally, it is recommended
to do a Factory Reset. To go one step further, unplug the DMS-800PV after the Factory Reset is complete for 10 minutes
then plug the DMS-800PV back in. Wait another 5 minutes before turning the DMS-800PV back on. While it is unplugged,
you can also delete and reinstall the Cary Audio Streamer 2.0 app. All settings will default to factory, requiring reconnecting
to network as well as re-indexing of connected USB HDDs and SD cards and reset all other system defaults.
29
