Rear Panel
9
8
10
POWER INPUT(AC IN):
* Connect to an AC power supply using the included power supply cord.
RS 232 PORT:
* The RS-232 port is used in conjunction with an external controller to control the
operation of the CDP 1 by using an external device.(This is for custom installation
use. Consult your dealer for more information.)
* The pin assignments of the XLR-type male analog outputs:
Pin 1: Signal ground
Pin 2: (non-inverting)
Pin 3: Signal - (inverting)
Connector ground lug: chassis ground
1
2
3
Refer to your amplifier's operating manual to verify that the XLR pin
assignments of its input connectors correspond to the CDP 1.
If they are different, wire the XLR cable so that the appropriate XLR
output pin connects to the equivalent XLR input pin.
10
1
2
3
4
5
6
7
8
9
AES/EBU
RIGHT
LEFT
AES/EBU
ANALOG OUTPUT
TRIGGER
INPUT
IR
INPUT
COAXIAL
TOSLINK
AC POWER
[
] 110-120V
[
] 220-240V
44.1kHz - 192kHz DIGITAL OUTPUT
CARY AUDIO DESIGN
CDP 1 HDCD PLAYER
APEX, NC, U.S.A.
HDCD
, High Definition Compatible Digital and Pacific Microsonics
are either registered trademarks or
trademarks of Pacific Microsonics, Inc. in the United States and /or other countries
.
HDCD system manufactured under license from Pacific Microsonics, Inc.
This product is covered by one or more of the following :
United States
5,479,168 5,638,074 5,640,161 5,808,574 5,838,274 5,854,600 5,864,311 5,872,531
Australia
669114
Other patents pending.
Country
Patent No.
Complies with FDA radiation
performance standards,
21CFR Subchapter J
This device complies with part
15 of the FCC Rules.Operation
is subject to the following two
conditions:(1) This device may
not cause harmful interference,
and (2) this device must accept
any interference received,
including interference that may
cause undesired operation.
RS 232
IR INPUT JACK:
* Use this jack to connect external IR sensors.
