•
Replacing a new fuse with 10A rating when the old one is broken, using no fuse or fuse with improper
rating may cause damage to this unit or even res. If a proper fuse is installed and electrical problems still
occur, please contact with any professional car shops for inquiry.
•
DO NOT connect other equipment with the car battery to avoid battery overheating.
•
Please make sure all the wiring connections & the cables of the Speakers are well- insulated. Otherwise,
this unit may be
damaged by short circuit.
•
If there is no ACC available, please connect ACC lead to the power supply with a switch.
•
If an external power amplifier is connected, please don't connect P.CONT lead to the power lead of the
external power amplifier, otherwise, electric spark or other damage
may be resulted.
•
Never ground the speaker output to prevent
the damage to the built-in power amplifier.
1. Disconnect battery
Before you begin, always disconnect the battery negative terminal.
Note:
If the unit is to be installed in a car equipped with an on-board drive or navigation computer, do not
disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these
conditions, use extra caution during installation to avoid causing a short circuit.
2. Remove unit from sleeve
Lift latches on both sides of sleeve to remove half-sleeve from the unit.
Mounting Sleeve Installation
1. Slide the mounting sleeve off the chassis, use the removal tools (supplied) to disengage it.
2. Check the dashboard opening size by sliding the mounting sleeve into it.
If the opening is too small, carefully cut or file as necessary until the sleeve easily slides into the opening.
Do not force the sleeve into the opening or cause it to bend or bow. Check for sufficient space behind the
dashboard for the unit chassis. This unit can be installed in any dashboard with a suitable 7.2-inch (W) x
2.04-inch (H) opening as shown above. The dashboard should be ¼-inch thick in order to support the unit.
3. Locate the series of bend tabs along the top, bottom, and sides of the mounting sleeve. With the sleeve
fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure
the sleeve to the dashboard.
4. Place the unit in front of the dashboard opening so the wiring can be brought through the mounting
sleeve. Follow the wiring diagram carefully and make certain all connections are secure and insulated with
wire nuts or electrical tape. After completing the wiring connections, turn the unit on to confirm operation
(vehicle ignition must be on). If the unit does not operate, re-check all wiring until the problem is corrected.
5. Make sure the radio is right-side up, then carefully slide the radio into the mounting sleeve until it is fully
seated and the spring clips lock it into place.
6. Secure the rear of the unit to the car body using the mounting bolt and rubber cushion.
7. Test the unit using the “Operation” instructions that follow.
Installation Guide