- 2 -
Only a certified technician should bias Carvin amps, this is very
dangerous, you can get hurt, please be very careful when working
with any tube amp!
If you have changed the tubes make sure they are a matched set.
-The Bias for the V3M, V3MC should be 80mA at 50W setting, with 120VAC.
STEP 1
These are the tools you will need:
1.
A flat head screw driver “small”.
2.
A multi-meter, w/ milli amp
reading.
3.
Banana to clip leads.
4.
Drill
5.
Amp stand (optional).
STEP 1A
You have to remove the bottom cover by
removing the screws as indicated. It’s a total of
10 screws.
STEP 2
Set it in an amp stand. Be very careful with the
tubes they can break.
NOTE: If you don't have an amp stand then
support the chassis on some blocks of wood so
that the power tubes are not touching anything -
they get very hot
