BRX18
BRX12
BRX18
BRX10
TYPICAL SETUP
BRX enclosures feature four input/output jacks (two 1/4" and two
Speakon) wired in parallel. Connect the BRX INPUT to any audio
amplifier capable of 8 ohm operation. Connect additional BRX
enclosures from the EXT.SYSTEM jack to the INPUT of the additional
enclosure (be sure the amplifier is capable of 4 ohm operation).
The BRX10 and the BRX12 feature a HIGH FREQUENCY ATTENUATION
(dB) switch for accurately adjusting the high frequency level. This is a
positive lock switch preset at six levels of attenuation. A good starting
point for this switch would be in the -6dB position, or straight up 12
o'clock. As you turn the switch CCW the attenuation doubles to -12dB,
then to -24dB, and finally OFF turns the high frequency driver off.
Switching CW the attenuation halves to -3dB and then 0dB which turns
the high frequency driver full on.
Carvin suggests the B-series and R-series bass heads to
power the BRX cabinents.
BRX SYSTEMS
BRX10
BRX12
BRX510
BRX512
BRX1018
BRX1218
B500
500w mono block bass Head
B1500
1900w mono block bass Head
R1000
bass Head
R600
bass Head