Configuration 3 - Speed Alert START SPEED:
There are two methods available for setting the Speed Alert Pattern
START
SPEED. This can be done by either
using the pushbutton to enter an exact SPEED value required, or driving the car at the precise speed.
3.1) Speed Alert Pattern START SPEED using the pushbutton (
Engine must be stationary
)
Firstly, consider the actual road speed (KPH) that you wish the display to start. This KPH value will be entered
as separate numbers, i.e. 100, 10 and 1. Any KPH value can be entered up to 299 KPH in steps of 1 KPH.
Perhaps write the required speed onto a piece of paper, e.g. 95 = 095.
On entering Configuration 3 when the engine is stationary, the display will show one Red LED followed by 2
Green LEDs on the
left
side of the display. This will be displaying the current 100 KPH setting. Static, (no
flashing) will represent 0x 100, 1 flash will represent 1x 100, 2 flashes will represent 2x 100. Quick presses of
the pushbutton will allow the value to be adjusted, however, only three values are available, 0x 100 1x 100
and 2x 100.
Pressing and holding the pushbutton for a minimum of 4 seconds will cause the configuration to move onto
the next KPH factor, 10 KPH. This value can also be adjusted with quick presses of the pushbutton which will
result in the value incrementing, e.g. static, (no flashing) will represent 0x 10 KPH, 9 flashes will represent 9x
10 KPH.
Pressing and holding the pushbutton again for a minimum of 4 seconds will cause the configuration to move
onto the last KPH factor, 1 KPH. This value can similarly be adjusted with quick presses of the pushbutton
which will result in the value incrementing.
If you now want to check or adjust the
end
KPH speed then hold down the push button for a minimum of 4
seconds to move onto the next Configuration Menu (4) as shown by 4 White LEDs, or to exit the Configuration
Menu refer back to
Note 1.
1
0
0
K
P
H
1
0
K
P
H
1
K
P
H
Example:
Start of sequence = 095 KPH
0 F
las
he
s
9 F
las
he
s
5 F
las
he
s
Configuration:
Start of sequence KPH
4
SPEED ALERT (OBD2)
