SA-361-30 Installation Instructions
Page 3 of 8
CP5165A
12/20/16
SPECIFICATIONS
UNPACKING
Inspect contents for shipping damage. If
found
alert carrier immediately
.
Contact supplier immediately if any items are
missing.
INSTALLATION
Proper installation of the unit is essential for years of safe, reliable operation. Please read all
instruction
before
installing the unit. Failure to follow these instructions can cause serious dam-
age to the unit or vehicle and may void warranties.
SAFETY PRECAUTIONS
For the safety of the installer, vehicle operator, passengers and the community please observe
the following safety precautions.
Failure to follow all safety precautions and instructions may
result in property damage, injury or death.
Qualifications -
The installer must have a firm knowledge of basic electricity, vehicle electrical
systems and emergency equipment.
Remote Panel Location -
Locate the hand control for easy access by the vehicle operator, typi-
cally underneath the vehicle dashboard in a location away from the driver’s or passenger’s legs.
DO NOT locate in air bag deployment area. Mounting hardware is not supplied.
Amplifier Mounting
- Flanges are provided for mounting (hardware not supplied). Assure clear-
ances before drilling in vehicle.
Wiring
- Use wiring capable of handling the current required. Make sure all connections are tight.
Route wiring to prevent wear, overheating and interference with air bag deployment. Install and
check all wiring before connection to vehicle battery.
Testing
- Test all siren functions after installation to assure proper operation. Test vehicle opera-
tion to assure no damage to vehicle.
This unit is not designed for motorcycle use.
Keep These Instructions
- Keep these instructions in the vehicle or other safe place for future
reference. Advise the vehicle operator of the location.
Speaker Load
Single 100W 11ohm
Input Current
8 AMPS (@14 VDC - single 100W speaker)
Standby Current
Less than 5mA
Output Power
105 WATTS RMS MAX. (15 VDC - single 100W speaker)
Siren Frequency
700Hz - 1500Hz (Two-Tone and Horn = 435 & 585Hz)
Tones / Cycle Rates
Horn
Wail
Yelp
Phaser
Two-Tone
Cycle Rates
109 CPS
13 CPM
190 CPM
15 CPS
60 CPM
High Voltage
Protection
16 - 18 VDC will cause siren output to cease, resume at normal voltage
Short Circuit Current
50 AMPS (supply circuit must be capable of supplying this for 1 second)
Operating Temp.
-15° F to +140°F
Controls
3-position rocker selector switch (Yelp, Wail and Standby).
3-position momentary rocker switch (Horn and Manual/Phaser toggle).
Auxiliary input.
8-position DIP switch option selector.
Connections
(10-Pin Connector)
(2) Power, (2) Speaker, Auxiliary
Switch inputs for Wail, Yelp, Horn, Manual/Phaser
Size
Control Panel: 3-3/4” Wide, 1-3/4” Deep, 1-1/4” High
Amplifier: 6" Wide, 4-1/4" Deep, 1-7/8" High
Weight
2 LBS.
Input Voltage
10 - 16 VDC (negative ground)
Qty Item
1 Amplifier
1 ED1773 Switch Panel Assembly
1 CP4688-10 10-Pin Terminal Block Plug
6 CP4062-K2523Terminal, 3/16” Insulated
1 CP5165 Instruction Manual
