17
CARSON Reflex Wheel-X 2.4 GHz 50 050 0030
GB
BEC-System / Connections to receiver
BEC-receiver:
Battery eliminator is installed in the receiver
circuitry. The receiver gets supplied with current
through the drive battery that runs the engine.
NiMH battery from 6 V to 8.4 V can be used for
the receiver. Batteries of higher voltage may
damage the receiver and servos.
Use only a speed controller which has the exclusive
connector for the BEC system.
Equipment for combustion engine
Receiver Batteries and two servos are not included in the kit.
Connector motor
Connector battery
Power Switch On-/Off
Steering servo
Channel 1
(not included)
Receiver
Do not connect a separate power
supply to the receiver!
Electronic speed controller
(not included)
ATTENTION
Make sure that male and female connectors
have the correct polarity.
Receiver
Make sure to
connect in
correct
direction.
Receiver switch
Receiver battery case NiMH-batteries
item No. 50 060 9000 are
recommended
Steering servo
Channel 1
(not included)
Throttle servo
Channel 2
(not included)
ATTENTION
When connecting servo leads to the receiver
always ensure that the yellow lead/wire is
facing inwards (towards the crystal).
