CarShow Installation Guide
CarShow
Copyright 2012 All Rights Reserved
Multi-Media Navigation System Installation Guide
CS-GM1014
Page 6
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the
vehicle. And mount the iPod Interface Connector in the vehicle. The following steps will help guide
you through this process.
STEP
4
Use Caution around SRS Components
I
t is the
installer’s responsibility
to ensure that the safety
equipment in the vehicle is
NOT
adversely affected by installation
of this system. Ensure that the routing of the harnesses do NOT
obstruct airbags, SRS or other safety devices.
Mount the GPS and Sat Radio antenna in a
location on the exterior of the Vehicle
Route the GPS harness away from other power harnesses in the
vehicle and locate the Antenna 12” away from the radio.
If the Antenna is Dash Mounted, it
MUST
be attached to a metal
plate 3”x3” to ensure acceptable GPS performance
Install the iPod interface connector in a
location accessible to the end-user
Locate the iPod interface module in an area which can be
serviced in the future.
The iPod cable is intended to be a serviceable item, which plugs
into the iPod/Sat radio Interface Module.
INSTALL THE CAR SHOWNAVIGATION SYSTEM
You will need to prepare the Car Show Navigation System for installation in the vehicle.
STEP
5
Remove the DVD Transport Screws
There are 2 x Phillips Transport Screws which protect the DVD
Mechanism during transportation.
Transport Screws must be removed prior to installation.
