Carscop 202005, Manual, Page: 7 / 18

7
When car is moving or engine is started, the system will upload the GPS & car status
information (0x0200) to platform server every 10 seconds (can change to other time interval), 2
minutes after the car stop moving or the engine is off, the system will stop upload GPS & car
information to server, only send heart beat (0x0506) to platform server every 2 minutes. The
upload data format & protocol please refer the CC888 protocol document.
5.4 Internet Control Command
Internet server can send command to device to control the car, the internet command detail
please refer the the CC888 protocol document. Some command also can be used to control the
car, the SMS commands please refer the following SMS list.
Lock 0x8323
Lock the door, when the door is locked, the engine start is disabled.
Unlock 0x8323
Unlock the door, when the door is unlocked, the engine start is enabled.
Flashing Light Finding Car 0x8322
The car light will flash 4 times to indicate where the car is, it is suit for finding car in night.
Beep Siren Finding Car 0x8322
The siren will beep and light will flash 4 times, it is suit for finding car in day time.
Remote Start Engine 0x8323
The car flash, and the siren beep one time, the system enter start engine process, the
system will check hand brake and car status, and the start the car engine (the T-Box will try to
start car engine 6 times till the engine is started), after the engine is started, the system will turn
on the ACC and and enter warm car status, the system will turn off the engine after warming car
30 minutes, and back to lock state again.
Notes:
1. If the hand brake is not pull ON and the gear is not in P position, the car will not
start the engine.
2. If the original car key is has RFID security system, the RFID bypass module should