Page 2
STEP 1 . From the carton c a r e f u l l y remove ( 2 ) plastic
legs, (1) hardware/equipment pack containing (2) pucks, (2)
controllers, (2) felt pads, (4) leg levelers and the fasteners
consisting of (4) #8 Washers & (4) #8 – 32 x 3/4” Machine
Screws.
STEP 2. Remove the game from the carton, place the game
with the face side (playing surface) down on a table or on the
floor.
STEP 3. Position Leg into base of game with black leg panel
facing out towards end of game. Line up holes for #8 – 32 x
3/4” machine screw. Place washer on machine screw & insert
through inside of leg assembly through pre drilled hole in leg.
Continue to screw into metal insert until tight. (Do not over
tighten these screws). Repeat for other leg. Now install black
leg levelers into leg inserts.
Step 4. Turn game over and rest legs on a flat surface.
Adjust leg levelers to level game.
STEP 5. Felt Pad Installation: Peel away the backing from each
Felt Pad and carefully
align
and press into position, centering
the pad on the controller. Do not use the controller without the
pads. Replace pads when worn to avoid scratching the play
surface.
STEP 6. Plug the games blower unit into a 110-120 volt AC
Polarized outlet only! This game is equipped with a polarized,
alternating line plug (a plug having one blade wider than the
other). This is a safety feature. If you are unable to insert the
plug fully into the outlet, try reversing the plug. If the plug still
fails to fit, your outlet is obsolete and should be replaced by a
qualified electrician. Do not alter this plug. Do not defeat the
safety purpose of the polarized plug.
RULES FOR PLAY
Play should be started with a 1-2-3 “face-off” by dropping the
puck in the center of the game. The object is to get the puck
into the opponents goal. The players should stand at opposite
ends of the game. Players may not cross beyond the center
line of the game with their disc controller. The goal must be
guarded from a position outside the “goal zone”. When a goal
is made, the puck is put in play by the player who was just
scored on. The winning score is set at a nominal figure by
agreement between players before starting play. Our scorer
goes from 1-10.
TABLE MAINTENANCE
Occasionally, some air holes in the playing surface may
become clogged. If this happens, you may reopen holes as
follows: #1 DISCONNECT THE CORD PLUG FROM THE
ELECTRICAL OUTLET. #2 Carefully push a thin, non-metallic
probe into each clogged hole. A broom straw or wooden
toothpick are good tools. Be careful not to damage the mouth
of the hole being opened. Warning: To avoid electrical
shock, never use a metallic probe to reopen air holes in play
surface.
DO NOT USE HOUSEHOLD WAXES ON SURFACE as the
“air cushion” may be affected due to the clogging of holes. If a
puck becomes rough, carefully sand by placing it on a piece of
fine sandpaper (#280 or 320 grit) and slide the puck back and
forth until smooth.
PRODUCT REGISTRATION:
Visit www.carrom.com to register your product(s) to receive the latest updates, special
offers and other product related information.
#8–32 x 3/4” Machine Screw
(4) required
#8x3/4 Washer
(4) required
