![background image](http://html.mh-extra.com/html/carrier/xct-7-40vk005-030s-7s-qee/xct-7-40vk005-030s-7s-qee_installation-and-owners-manual_2560361015.webp)
(1) Positioning Wall bracket & Locating Wall Holes
Fix the bracket according to the installation location and the pipe layout of indoor unit (please refer to the installation
diagram). Installation should be done under the crossbeam or on the flat wall near the pillar. First, fix the pad with a
steel nail on the wall. Drop a thread with a bolt through the pad center or use a level meter to determine the level.
Then, fix it with a concrete steel nail, and measure the position of the wall hole A.
(2) Drilling Hole & Mounting Guard Ring
Drill a hole of 60mm bore with a slight tilt downwards to the outside, mount the guard ring, and seal it with gesso or
putty after finishing the installation.
(3) Arranging Wiring of Indoor Unit
Arrange the layout of the connection pipe, drain pipe, connecting line, signal line, and air refreshing pipe according
to the locations of your indoor unit with drainage hose lower and the connecting line higher. materials for heat pres-
ervation.
3. Installation diagram of Indoor Units:
Arrangement of piping directions
rear left
rear right
right
below
left
Attention must be paid to
the rising of the drain
lashing wire
place of drooping thread
wall bracket
positioning
hole
thread
drooping piece
level location
Installation Procedures
more than
10cm
more than 10cm
more than 15cm
cross section of wall hole
side of indoor
wall hole
side of outdoor
thickness
of wall
60 mm
8
Summary of Contents for XCT 7 40VK005-030S-7S-QEE
Page 31: ...The manufacturer reserves the right to change any product specifications without notice ...
Page 58: ...Il produttore si riserva il diritto di modificare le specifiche del prodotto senza preavviso ...
Page 85: ...Le fabricant se réserve le droit de modifier les spécifications du produit sans préavis ...
Page 112: ...Der Hersteller behält sich das Recht vor Produktspezifikationen ohne Vorankündigung zu ändern ...