56
Fig. 80 — Return Air Smoke Detector; Shipping
Position
Completing Installation of Return Air Smoke Sensor
1. Unscrew the two screws holding the Return Air Smoke
Detector assembly. See Fig. 81, Step 1. Save the
screws.
2. Turn the assembly 90 and then rotate end to end. Make
sure that the elbow fitting is pointing down. See Fig. 81,
Step 2.
3. Screw the sensor and detector plate into its operating po-
sition using screws from Step 1. See Fig. 81, Step 3.
4. Connect the flexible tube on the sampling inlet to the
sampling tube on the basepan.
Additional Application Data — Refer to the application data
sheet titled “Factory Installed Smoke Detector for Small and
Medium Rooftop Units, 2 to 25 Tons” for discussions on addi-
tional control features of these smoke detectors including mul-
tiple unit coordination.
Fig. 81 — Completing Installation of Return Air Smoke Sensor
RETURN AIR
S
MOKE DETECTOR
(A
S
S
HIPPED)
S
TEP 1
S
TEP 2
S
TEP
3
Summary of Contents for WeatherMaker 48TC 04
