Installing the VVT Bypass II
VVT Bypass II Controller
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
6
To install the VVT Bypass II:
1
Mount the controller
(page 7).
2
Wire the controller for power
(page 12).
3
Set the controller's address
(page 14).
4
Wire the controller to the BACnet MS/TP or BACnet ARC156 network
(page 14).
5
Wire the inputs and outputs
(page 16).
Field-supplied hardware
Each VVT Bypass II installation requires the following field-supplied components:
•
damper
•
damper actuator (if high-torque actuator or slaved dampers are required)
•
duct air temperature sensor
•
transformer— 24 Vac, 40VA
•
wiring
Installing the VVT Bypass II
Summary of Contents for VVT Bypass II
Page 51: ......