background image

 

User’s Information Manual for the operation and

maintenance of Energy Recovery Ventilators

 

A95044

 

OPERATING YOUR ENERGY RECOVERY VENTILATOR (ERV)

 

Your ERV is designed to operate as an integral part of your total heating and cooling system.

 

Low Exchange Mode

 

—If the relative humidity inside the building is lower than selected, air exchange would occur with the outside

at high speed. If the relative humidity level inside the building is higher than selected, air exchange would occur with outside at low
speed. This ensures continuous air exchange for constant air quality.

 

Intermittent Mode

 

—If the relative humidity inside the building is higher than selected, no air exchange would occur, and the system

would turn off. If the relative humidity inside the building is lower than selected, air exchange would occur with outside at high speed.
This mode is ideal for maintaining the proper humidity level when the continuous mode cannot.

 

PERFORMING ROUTINE MAINTENANCE

 

1. The motors are factory lubricated for life. Lubricating the bearings is not recommended.
2. The core should be vacuumed every three months to remove dust that would inhibit the energy transfer. 

 

Do not use water. The

core should only be serviced when the outdoor temperature is between 60°F(16°C) and 75°F(24°C) and dry.
NOTE:

 

If the edges of the core are soft, do not try to service the core. The air passages can be damaged and / or closed off by
handling it or trying to remove it.

3. A dirty air filter will cause excessive strain on the blower motor. The filters in your ERV are washable, and should be cleaned

every 3 months. Use a vacuum cleaner to remove the heaviest portion of accumulated dust, then wash in lukewarm water.

 

NOTE:

 

Do NOT clean these filters in a dishwasher or dry them with heating appliances as they will be permanently damaged.
Use lukewarm water to clean filters. Replace filters only when they are completely dry.

4. Regularly check the screen on the exterior intake hood and clean when necessary.

 

WARNING: Before installing or servicing system, always turn off main power to system. There may be more than 1 discon-

nect switch. Turn off accessory heater power if applicable. Electrical shock can cause personal injury or death.

CAUTION: Although special care has been taken to minimize sharp edges in the construction of your unit, be extremely

 careful when handling parts or reaching into the unit.

AIR EXCHANGE

OFF

LOW

INTERMITTENT

ON

% RELATIVE HUM.

EXT. TEMP.

21

°

C+ / 70

°

F+

10

°

C / 50

°

F

0

°

C / 32

°

F

60%
55%
45%

 

VL3A

 

ENERGY RECOVERY VENTILATOR

Reviews: