9
INSTALL UNIT INTO WALL SLEEVE
1. Carefully remove shipping tape from the front
panel and vent door. See
Fig. 9
.
2. Remove shipping screw from the vent door, if
present. See Fig. 10.
3. Remove front panel. See Fig. 11.
4. Lift unit level and slide unit into wall sleeve
until foam seal rests firmly against front of wall
sleeve.
5. Secure with four screws (supplied) through the
unit flange holes. See Fig. 12.
6. Reinstall front panel. See Fig. 13.
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Failure to remove shipping tape and screw will prevent
fresh air vent door from opening and may result in damage
to vent door cable
CAUTION
!
Shipping
tape
A07066
Fig. 9 – Shipping Tape Location
Remove shipping
screw if present
A07067
Fig. 10 – Shipping Screw Location
Pull out at the bottom to release it from the tabs
(1). Then lift up (2).
A07064
Fig. 11 – Removing Front Panel
A07057
Fig. 12 – Securing Unit
Place tabs over top rail (1). Push Inward at
bottom until panel snaps into place (2).
A07065
Fig. 13 – Replacing Front Panel
