![background image](http://html1.mh-extra.com/html/carrier/mmk-ap0073h2ul/mmk-ap0073h2ul_installation-manual_2561389023.webp)
High Wall Type
Installation Manual
– 22 –
EN
Procedure
2
Each time
button is pushed, indoor unit
numbers in the control group change cyclically.
Select the indoor unit to change settings for.
The fan of the selected unit runs and the louvers
start swinging. The indoor unit can be confirmed for
which to change settings.
Procedure
3
Specify CODE No. [
] with temp. setup
/
buttons.
Procedure
4
Select SET DATA [
] with timer time
/
buttons.
Procedure
5
Push
button. When the display changes from
flashing to lit, the setup is completed.
• To change settings of another indoor unit, repeat
from Procedure
2
.
• To change other settings of the selected indoor
unit, repeat from Procedure
3
.
Use
button to clear the settings.
To make settings after
button was pushed,
repeat from Procedure
2
.
Procedure
6
When settings have been completed, push
button to determine the settings.
When
button is pushed, “SETTING” flashes
and then the display content disappears and the air
conditioner enters the normal stop mode.
(While “SETTING” is flashing, no operation of the
remote control is accepted.)
Filter sign setting
According to the installation condition, the lighting
time of the filter sign (Notification of filter cleaning)
can be changed.
Follow to the basic operation procedure
(
1
→
2
→
3
→
4
→
5
→
6
).
• For the CODE No. in Procedure
3
, specify [01].
• For the [Set data] in Procedure
4
, select the SET
DATA of filter sign lighting time from the following
table.
To secure better effect of heating
When it is difficult to obtain satisfactory heating due
to installation place of the indoor unit or structure of
the room, the detection temperature of heating can
be raised. Also use a circulator or other device to
circulate heat air near the ceiling.
Follow to the basic operation procedure
(
1
→
2
→
3
→
4
→
5
→
6
).
• For the CODE No. in Procedure
3
, specify [06].
• For the set data in Procedure
4
, select the SET
DATA of shift value of detection temperature to
be set up from the table below.
SET DATA
Filter sign lighting time
0000
None
0001
150 H (Factory default)
0002
2500 H
0003
5000 H
0004
10000 H
SET DATA
Detection temp shift value
0000
No shift
0001
+1.8 °F (+1 °C)
0002
+3.6 °F (+2 °C)
0003
+5.4 °F (+3 °C) (Factory default)
0004
+7.2 °F (+4 °C)
0005
+9.0 °F (+5 °C)
0006
+10.8 °F (+6 °C)
22-EN
+001111053901_00Ta.book Page 22 Monday, January 17, 2011 11:35 AM