6
REMOTE CONTROL FUNCTIONS
Pressing the On/Off Button
ON/OFF
Indicator
When the air conditioner is not in operation, the remote control
will display the last set point and mode.
S
Press the On/Off button to start the unit.
-- The unit will start in the last operating mode and set
point. The ON/OFF indicator will appear.
S
Press button On/Off to stop the unit.
-- All indicator lights on the unit will go out, and the remote
control will display the set point and mode.
NOTE:
If the On/Off button is pressed too soon after a stop, the
compressor will not start for 3 minutes due to the inherent
protection against frequent compressor cycling. The unit will only
emit an audible beep when the signals are received correctly.
Selecting an Operating Mode
Use the Operating Mode button to select one of the available
modes.
Auto
Cool
Dry
Heat
Fan
AUTO
COOL
DRY
HEAT
FAN
A07548
Setting the Room Temperature Set Point
Pressing the increase temperature set point
and decrease
buttons will raise or lower the temperature.
The unit will confirm signal receipt with a beep and the value of
the set temperature on the display will change accordingly.
The temperature can be set between 62
_
F (17
_
C) and 84
_
F
(29
_
C).
NOTE:
In Cooling mode, if the temperate selected is higher than
the room temperature, the unit will not start. The same applies for
the Heating mode if the selected temperature is lower than the
room temperature.
Selecting the Fan Speed
high
medium
low
The fan speed can be selected by pressing the
FAN SPEED
button.
NOTE:
When fan is in AUTO mode, no speed will be displayed.
NOTE:
When the unit is on, the fan will run continuously in
cooling or heating. When in heating, there might be situations
where the fan will slow down or shut off to prevent cold blow.
Selecting the Horizontal Direction Louver Position
The airflow direction can be adjusted to optimize air distribution.
Press the AIR DIRECTION button repeatedly to choose one of the
louver positions.
In the Cooling, Dehumidification, and Fan Only mode, the louver
will swing in the cooling range. In the Heating mode, the louver
will swing in the heating range.
NOTE:
Always use the remote control to adjust the louver
position, otherwise abnormal operation may occur. If the louver is
manually adjusted out of its range, turn the unit off and then on
again.
Auto Swing
To have the louver moving continuously, push the SWING button.
Push again to stop the louver.
Selecting Vertical Direction of the Louver
The vertical louvers can be adjusted manually to direct the airflow
to achieve the optimal comfort in the space.
A07543
Timer Function
TIMER ON (to start the unit) and TIMER OFF (to stop the unit)
can be used separately or together.
Timer ON only
TIMER ON
This function will allow the unit to start automatically after a set
number of hours. The TIMER ON can be set while the unit is on
or off.
UNIT ON
-- Press the TIMER ON button. “0:00” will be displayed. Every
time you push the button, the time increases by increments
of .5 hours until 10 hours is reached. After 10 hours, the
increases are in increments of 1 hour.
-- When the TIMER ON is set, the TIMER light on unit
illuminates. The unit will shut off and it will start again after
the set time elapses.
UNIT OFF
-- Set the timer described in the UNIT ON section.
-- The unit will start when the set time elapses.