![background image](http://html1.mh-extra.com/html/carrier/bacview/bacview_installation-and-user-manual_2563782020.webp)
The BACview®6 device
BACview®
CARRIER CORPORATION ©2021
Installation and User Guide
All rights reserved
16
4
Insert the other 4 wires into the BAC
view
®
6
device's screw terminal connector. If wiring 2 cables, insert like-
colored wires into each terminal.
+
1
2V
Rn
e
t–
Rn
et+
G
n
d
CAUTION
Allow no more than .06 inch (1.5 mm) bare communication wire to protrude. If bare communication
wire contacts a metal surface other than the terminal block, the sensor may not communicate correctly.
5
Insert the screw terminal connector into the BAC
view
®
6
device with the screw heads facing out.
NOTE
If mounting the BAC
view
®
6
device on a panel door, feed the cable through the door cutout.
6
Connect the other end of the cable to the controller's
Rnet
port or to an SPT sensor.
NOTES
○
Insert the shield wire with the ground wire into the controller's
GND
terminal.
○
Use the same polarity throughout the Rnet.
7
Turn on the controller's power.
Summary of Contents for BACview
Page 4: ......
Page 32: ......
Page 33: ...CARRIER CORPORATION 2021 Catalog No 11 808 486 01 9 20 2021 ...