Carrier AQUAFORCE 30XA080, Installation Instructions Manual

Page: 47 / 80

47
GATE VALVE*
STRAINER*
VIBRATION
ELIMINATORS*
BALANCING VALVE/
SHUT OFF*
POWER
FD
FD
CONTROL
PRESSURE/
TEMPERATURE TAPS*
PUMP
DRAIN
SHUTOFF
VALVE
NOTES:
1. Chiller must b e installed level to maintain proper compressor oil return.
2. Piping shown are general points-of-connection guides only and are not
intended for a specific installation. Wiring and piping shown are for a q uick
overview of system and are not in accordance with recognized standards.
3. All wiring must comply with applica b le local and national codes.
4. All piping must follow standard piping techni q ues. Refer to Carrier System
Design Manual or appropriate ASHRAE (American Society of Heating,
Refrigeration, and Air Conditioning Engineers) hand
b ook for details.
5. A 20 mesh strainer is re q uired withinh 10 ft (3 m) of the cooler.
LEGEND
*Field-installed.
FD —
Fused Disconnect
Airflow Through Condenser
Chilled Water Piping
Power Wiring
Fig. 19A — 30XA Typical Piping and Wiring (Units without Hydronic Package)
a30-4114
Fig. 19B — 30XA Typical Piping and Wiring (Units with Hydronic Package)
FIELD- S UPPLIED
FU S ED DI S CONNECT
CONTROL POWER
FIELD- S UPPLIED
FU S ED DI S CONNECT
UNIT POWER
AIRFLOW
DRAIN S HUTOFF VALVE
S TRAINER *
GATE VALVE *
PUMP
PRE SS URE/
TEMPERATURE
TAP S*
VIBRATION
ELIMINATOR S*
BALANCING VALVE/
S HUTOFF * NOTES:
1. Chiller must
b e installed level to maintain proper
compressor oil return and hydraulics.
2. Wiring and piping shown are general points-of-
connection guides only and are not intended for a
specific installation. Wiring and piping shown are
for a
q uick overview of system and are not in
accordance with recognized standards.
3. All wiring must comply with applica b le local and
national codes.
4. All piping must follow standard piping techni q ues.
Refer to Carrier System Design Manual or appro-
priate ASHRAE (American Society of Heating,
Refrigeration, and Air Conditioning Engineers)
hand
b ook for details.
5. Air separator re q uired as close to chiller as possi-
b le (except primary/secondary systems).
6. 20 mesh strainer re q uired for open loop systems.
LEGEND
*Field-installed.
Airflow Through Condenser
Power Wiring
Chilled Water Piping