4
qualified personnel should install, repair, or service heating
equipment.
Untrained personnel can perform basic maintenance func-
tions such as cleaning and replacing air filters. All other
operations must be performed by trained service person-
nel. Observe safety precautions in this manual, on tags and
labels attached to the furnace, and other safety precautions
that may apply.
Recognize safety information. This is the safety-alert sym-
bol
. When you see this symbol on the furnace and in
instructions or manuals, be alert to the potential for person-
al injury.
Understand the signal words DANGER, WARNING, and
CAUTION. These words are used with the safety-alert sym-
bol. DANGER identifies the most serious hazards which
will
result in severe personal injury or death. WARNING
signifies hazards which
could
result in personal injury or
death. CAUTION is used to identify unsafe practices which
would
result in minor personal injury or product and prop-
erty damage.
Starting your furnace
Instead of a continuously burning pilot flame, your furnace
uses an automatic hot surface ignition system to light the
burners each time the thermostat turns your furnace on.
Follow these important safeguards:
• Never attempt to manually light the burners with a match
or other source of flame.
• Read and follow the operating instructions on the furnace,
especially the item that reads as follows:
Wait 5 minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas,
STOP!
Follow “B’’
in the above safety information on this label. If you don’t
smell gas, go to the next step.
• If a suspected malfunction occurs with your gas control
system, such as the burners do not light when they should,
refer to the shutdown procedures on the furnace or see
“Shutting Down your Furnace” section in this manual, then
call your dealer as soon as possible.
WARNING
Should overheating occur or the gas valves fail to
shut off the gas supply, turn off the manual gas
valve to the furnace BEFORE turning off the elec-
trical supply. (See Fig. 8.) A failure to follow this
warning could result in a fire or explosion, and
personal injury or death.
!
6
!
• Check Air Filter: Before attempting to start your
furnace, be sure the furnace filter is clean and in place.
(See the maintenance section of this manual.) Then pro-
ceed as follows:
Steps for starting your furnace
1. Set your room thermostat to the lowest temperature
setting. (See Fig. 7.)
2. Close the external manual gas valve. (See Fig. 8.)
7
8
9
3. Turn off electrical supply to the furnace. (See Fig. 9.)
4. Remove the furnace access door(s).
a. Downflow/Horizontal—Remove blower door after
removing 2 screws first, then remove the control
door. (See Fig. 10.)
b. Upflow—Remove control door. (See Fig. 11.)
10
11
5. Turn the control knob on the gas valve to the OFF posi-
tion and wait 5 minutes. (See Fig. 12.)
6. After waiting 5 minutes, turn the control knob on the
gas valve to the ON position. (See Fig. 13.)
7. Replace the access door(s). See Fig. 14 for upflow and
Fig. 15 for downflow. Replace control door first on
downflow furnaces. Replace blower door and secure
with 2 screws.
8. Turn ON the electrical supply to the furnace. (See
Fig. 16.)
