23
FIELD--INSTALLED ACCESSORIES (CONT.)
Condensate Drain Kit
Part No.: DRAIN--KIT--4PK
This universal drain kit may be used internally or
externally to route condensate to a drainage system. It
can be field--installed on any Carrier wall sleeve.
Although Carrier units are designed to dissipate all
the condensate generated during normal cooling,
there may be times when abnormal conditions cause
more condensate than the unit can dissipate. If
condensate that drips from the wall sleeve is
objectionable, this internal/external drain kit should
be installed.
The drain kit may be attached to the exterior right or
left side of the wall sleeve for external draining or
mounted to the room side of the wall sleeve for
internal draining.
A 6 inch straight tube and 90
_
curved tube are
supplied to simplify any application
(1/2” OD
copper).
IMPORTANT: For internal drains installed
in the plastic wall sleeve, the drain must be
installed on the flat area of the sleeve. It
cannot be installed in the wafer area.
A07748
Drain Kit
Power Vent with Power Door Kit
Part No.: 52M--PWRVENT--DOOR
Carrier’s power vent kit, utilizing a specially
designed fan, when installed in the unit’s fresh air
vent, will supply up to 95 cfm of outside air into the
room. The power vent will only operate when the unit
fan runs, and the unit will automatically open or close
the vent door, depending on the operation of the fan.
The kit comes pre--assembled from the factory and is
very easy to install.
A07749
Power Vent with Door Kit
Replacement Filters
Part No.: 52M--AIRFILT--10PK
The Carrier 52M model replacement air filters come
in packages of 10. The filters save energy by
preventing the evaporator coils from being plugged
with dirt and lint. These economical and sturdy filters
are interchangeable and may be washed, vacuumed,
and reused.
A07749
Replacement FIlters
Baffle Kit
Part No.: BAFFLE--KIT--1PK
the accessory baffle kit ensures a good seal between
the unit and the exterior grille to prevent air
recirculation, which can cause system failure. The
accessory baffle kit is required for applications where
a factory wall sleeve is used without a factory exterior
grille.
A07275
Baffle Kit
52M