PROGRAMMING NOTES
If only 1 Occupied period is selected in step 1 on page 8, Occupied 2 & 3
programming steps are
Further, if only 2 occupieds are selected, Occupied 3 programming
steps are skipped.
skipped.
Heat & Cool setpoints for Occupied 1 are the same for every day of the week.
Heat & Cool setpoints
each day of the week, if desired.
for Occupied 2 & 3 can be adjusted differently for
If the start time is set later in the day than the stop time,
the program will run from the start time to
the stop time on the same day.
For example: 9:00pm start, 8:00am stop,
on MTWTF. In this example the program will run from 12:00am MTWTF to
8:00am MTWTF and again
midnight and from midnight to
from 9:00pm MTWTF to 12:00pm MTWTF.
The Unoccupied settings take effect at all times when:
(
1
) the program is on
and
(
2
) the current time is outside a preset occupied
period.
If the
same
start and stop times are programmed in for an occupied period,
then it will run 24 hours.
If one occupied period starts and stops within another occupied period,
the lower occupied # has
For example: If Occupied 3 is programmed to be “on” 24 hours,
and Occupied 2 is
settings will take over from occupied 3 between
priority.
programmed to run that day, then Occupied 2
Occupied 2 start and
stop times.
For this reason start and stop times aren’t necessary for unoccupied.
Programming
Occupied & Unoccupied Periods
Page 12