8.7 POWER-SELECTION OPERATION
This function is used when the circuit breaker is shared with other electrical
appliances. It limits the maximum current and power consumption to 100%,
75%, or 50% and can be implemented by POWER-SELECTION. The lower
percentage, the higher saving and also longer compressor lifetime.)
1. Press MENU button for enter menu setting and press TEMP. button to select
POWER-SEL
Blink only triangle
MENU
MEN
°C
2. Enter POWER-SEL setting by press MENU button again.
MENU
MEN
°C
3. Select POWER-SEL level by press TEMP. button.
°C
100%
75%
50%
4. Con
fi
rm POWER-SEL level by press MENU button.
MENU
MEN
°C
5. Leave from menu setting display by select EXIT.
MENU
MEN
°C
Note:
●
Due to the reason that POWER-SELECTION function limits the maximum
current, inadequate cooling capacity may occur.
DISPLAY LAMP BRIGHTNESS ADJUSTMENT
9
To decrease the display lamp brightness or turn it off.
1. Press and hold
FAN
FAN
for 3 seconds until brightness level (
,
,
or
) is shown on remote control LCD then release the button.
2. Press
Rise
or
Decrease
to adjust brightness in 4 levels.
Remote control
LCD
Operation display
Brightness
Lamp illuminates full brightness.
100%
Lamp illuminates 50% brightness.
50%
Lamp illuminates 50% brightness and the
operation lamp is turned off.
50%
All lamps are turned off.
All turned off
●
In the examples of
and
, the lamp illuminates for 5 seconds before going off.
AUTO RESTART FUNCTION SETTING
10
This product is designed so that, after a power failure, it can restart automatically
in the same operating mode as before the power failure.
Information
The product is shipped with Auto Restart function in the ON position.
Turn it OFF if this function is not required.
How to turn OFF the Auto Restart Function
●
Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds but OPERATION lamp does not blink).
How to turn ON the Auto Restart Function
●
Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds and OPERATION lamp blink 5 time/sec for 5 seconds).
Notes :
●
In case of ON timer or OFF timer are set, AUTO RESTART OPERATION
does not activate.
●
Default setting of AUTO RESTART OPERATION is ON.
SELF CLEANING OPERATION
(COOL AND DRY OPERATION ONLY)
11
To protect bad smell caused by the humidity in the indoor unit.
1. If the
button is pressed once during “Cool” or “Dry” mode,
the fan will continue to run for other 30 minutes, then it will turn off
automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
more 2 times within 30
seconds.
01_OM_1129850204_EN.indd 7
01_OM_1129850204_EN.indd 7
8/1/2564 BE 15:38
8/1/2564 BE 15:38
