40SMC---N
GB - 12
Alarm code, accessories and guide for the owner
Alarm code
A diagnostic system is contained in the electronic card to
“check” the system integrity.
When the diagnostic system is under alarm, the red LED
installed onto the main card flashes as indicated below:
• 0,5 sec ON and 0,5 sec OFF with a 5 second pause before the
error code is repeated.
• The number of flashes depends on the error that has been
detected.
Not all of the errors can be reset (see table below).
Error
Error
Resettable
code
*
3
Air temperature sensor
YES
4
Internal battery temp. sensor
YES
5
External battery temp. sensor
YES
7
Outdoor unit error
YES
10
EEPROM faulty
YES
11
Card serial number faulty
YES
12
Address/zone number incomplete
YES
*
NO: Turn off power supply to the system, check and repair, if necessary.
Turn on power.
YES: Check
Guide for the owner
When installation and tests are completed explain the Operation
and Maintenance Manual to the owner, with particular attention to
the main operating modes of the air conditioner, such as:
• Turning the unit on and off.
• Functions of the remote control.
Leave the two installation manuals for the indoor and outdoor
units with the owner for future use during maintenance operations
or for any other needs.
Accessories
For accessories refer to the product catalogues and documents.
/
/
1
1
1
J6A
J6B
1
J18
J11
1
J5
1
J8
1
J15
J10
1
J17
J20
1
J13
1
1
J7
1
J2
J1
1
J4
J3
PUMP SENSOR
To make electric connections you need to modify the cables connecting the N or C pole of the terminal block to the J3 pole of the card and insert
the pump contact according to the instructions shown in the diagram above.
Electric connection
Electric connections for auxiliary pump installation
40SMC018N-40SMC024N- 40SMC028N- 40SMC036N- 40SMC048N- 40SMC060N
