![background image](http://html1.mh-extra.com/html/carrier/40qq-series/40qq-series_installation-instructions-manual_2561994043.webp)
43
ADVANCED CONTROL
REQUIREMENT
NOTES
:
S
Powering on the unit and interface for the first time, it
takes time for the remote control to recognize the
operation input. This is not a malfunction.
S
For details on the auto address setting of air
conditioners when operating together with VRF system
(adjust the auto address setting on the circuit board of
the outdoor interface).
S
Turn on the indoor unit first. Refer to the installation
manual of the air conditioner about its power supply.
S
When shipped from the factory, all of the setting are set
to [ Factory default ]. Change the setting using the main
remote control (wired remote control).
S
The settings cannot be changed using the wireless
remote control, the sub remote control, or a system
without a remote control (system with only the central
remote control). Therefore, prepare the main remote
control and install.
Functional setting by DN code
Changing of settings for applicable controls
(DN code setting)
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Be sure to stop the air conditioner before making
settings).
Fig. 67 - Field Settings Menu
Procedure 1
1. Push the
[
MENU ]
button.
2. Push the
[
MENU ]
/
[
]
button
simultaneously for more than 4 seconds.
3.
P
ush the
[
] / [
]
button to select “7.
DN setting” on the “Field setting menu” screen.
4. Then push the
[
F2]
button.
5. Move the cursor to select “DN code” with the “<”
[F1] button.
6. Set “DN code” with the
[
] / [
]
button.
7. Move the cursor to select “data” with the
[
F2]
button, then set “data” with the
[
] /
[
]
button.
Fig. 68 - DN Setting
Procedure 2
Refer to this installation manual for details about the DN
code and data.
Fig. 69 - DN Code and Data
Procedure 3
1. Push the
[
MENU ]
button to set the other DN
codes.
2. After “Continue?” is displayed on the screen, push
the “Yes”
[
F1 ]
button.
Procedure 4
1. Push the “No”
[
F2]
button to finish the setting
operation.
2.
appears on the screen for a while.
3. Then the screen returns to the “Field setting menu”
screen.
40Q
Q
Summary of Contents for 40QQ Series
