6
38AW-
The indoor/outdoor connecting pipes can be connected to
4 directions (See fig. 4)
Take off the knockout part of the pipe cover in which pipes
or wires pass through the base plate.
Do not remove the pipe cover from the cabinet so that the
knockout hole can be easily punched.
To knock out, punch the 3 connected parts with a
screwdriver and remove the pipe cover by hand
(See fig. 5).
After marking the knockout hole, remove the burr and
mount the attached protective bush and guard material for
pass-through part in order to protect pipes and wires.
Installation
(Fig. 4 - 7)
Before installation, check strength and horizontality of the base so that abnormal sound does not generate.
According to the dimensions and clearances, fix the base firmly with the anchor bolts (Anchor bolt, nut: M10 x 2 pairs). If
the outdoor unit is installed in a very windy place, protect the fan with a wind protection screen and check that it works
correctly.
Refrigerant pipes; Pipe insulating material (polyethylene foam, 6 mm thick), Putty, PVC tapes.
- Philips screw driver
- Cutter drill (65 mm)
- Spanner
- Pipe cutter
- Cutter
- Reamer
- Gas leak detector
- Meter
- Thermometer
- Volt-ohm-milliammeter
- Electro circuit tester
- Hexagonal wrench
- Flare tool
- Pipe bender
- Water level
- Metal saw
- Hammer
Required tools for installation
Filed supplied material
Knockout procedure
(Fig. 4, 5)
How to remove the front panel
(Fig. 6)
1. Remove screws of the front panel (See fig. 6).
2. Pull the front panel downward.
English