Carrier TRANSICOLD PrimeLINE 69NT40-571-001, Operation And Service Manual, Page: 60 / 186

T-372 4–24
4.7.2.b Enabling or Disabling the Controller Wireless Network
1. On the keypad, press the ALT. MODE key.
2. Use the Arrow keys until "nEt" is displayed, then press the ENTER key.
3. Use the Arrow keys until "EnbL" is displayed, then press the ENTER key. The right display value will flash.
4. Use the Arrow keys to select "On" or "OFF, then press the ENTER key to confirm the selection.
4.7.2.c Looking Up the Controller Wireless Network Passcode
1. On the keypad, press the ALT. MODE key.
2. Use the Arrow keys until "nEt" is displayed, then press the ENTER key.
3. Use the Arrow keys until "PASSw EntR" is displayed, then press the ENTER key.
4. The display will show the eight character passcode that is required to connect a device to this unit’s control
-
ler. Write this value down.
4.7.2.d Communicating with the Controller using DataLINE Connect (IOS Device)
This procedure explains how to open the DataLINE Connect application and connect it directly to a unit’s controller.
1. Open the DataLINE Connect application.
2. Open the WiFi Settings menu (or Settings menu).
3. Under “Wi-Fi Login Credentials”, type in the Container ID of the unit to connect to. If this unit has already
been entered, select from the list of available wireless connections.
4. Next to “Passcode” (or “Token”), enter the passcode obtained from the Net menu on the display if it is not
already shown there. See Section 4.7.2.c for reference.
5. Select Login.
6. When DataLINE connect is connected, a message will appear “Connected to the WIFI successfully”.
7. After clicking OK to the message, the features of DataLINE Connect are now available. Refer to DataLINE
Connect user manual for more detailed procedures for using DataLINE Connect.
Table 4–6 Wireless Settings Menu (nEt) Options
Option Description
EnbL Enable / Disable Wireless Connection (On/Off).
If On, wireless mode shall be initialized according to the last saved wireless role. If Off, all
existing wireless connections will be shut down and wireless is disabled.
• Controller will enable wireless by default.
• Wireless will not be initialized if the system is running a battery and not on AC / USB 5V.
• Wireless can be forcefully shut down in some cases during battery operation.
PASSW View Wireless Connection Passcode.
The wireless connectivity passcode accessed here can establish a connection from your
wireless computer / tablet / phone to the ML5 controller.
• Passcode resets every four hours (based on system clock).
• Passcode is good for the customer's fleet (assuming all clocks are set properly).
• If communicating at the passcode change time boundary, the session can run for an
additional 4 hours without changing the passcode.