Carparelli Infiniti C-ZE1, Operation Manual

Page: 5 / 14

8 9
Using the Tuner
Using the Tuner
• Setting the C-ZE1 to the bypass condition
In play mode or rhythm mode ( p. 12), press the
Tuner button on top panel twice. When the
indication "bP" appears on the display, release the
switch within 1 second.
• Setting the C-ZE1 to the mute state
In play mode or rhythm mode ( p. 12), press the
TUNER button . Wait until the indication “bP”
on the display changes to "Mt" and then release
the button.
The bypass or mute condition cannot be activated when
the unit is in edit mode ( p. 14).
Switch to bypass or mute
To use the tuner function of the C-ZE1, the built-in effects must be bypassed (temporarily
turned off) or muted (original sound and effect sound turned off).
Play the open string to tune, and adjust the pitch.
To fine-adjust the reference pitch of the C-ZE1
tuner, turn the [VALUE] knob in the bypass/mute
condition.
When you turn the knob, the current reference pitch
is shown for a time on the display. The default setting
is 40 (center A = 440 Hz).
While the reference pitch is shown, turn the
[VALUE] knob to adjust the value in the range from
35 – 45 (center A = 435 to 445 Hz).
When power is turned off and on again, the reference
pitch setting will be reset to 40 (center A = 440 Hz).
Press the Tuner button until Bank selection returns
Tune your instrument
Adjusting the reference pitch of the tuner
Return to play mode
NOTE
NOTE
Pitch is high Pitch is correct
Pitch is low
Indication turns faster the more the pitch is off
The left side of the display shows the note
which is closest to the current pitch. The right side of the display shows a symbol that
indicates by how much the tuning is off.
Patch change at bypass/mute
When you press the Tuner/Bypass/Mute
button while playing your instrument, the
sound may change momentarily just before
the bypass/mute condition is activated.
This is because the C-ZE1 switches to
the next higher or lower patch when the
button is pressed slightly earlier.
( W h e n y o u c a n c e l t h e b y p a s s / m u t e
condition, the original patch number will be
active again.)
This behavior is not a defect. It is due to the
very high speed at which the C-ZE1
responds to patch switching. To prevent the
s o u n d c h a n g e c a u s e d b y t h e a b o v e
condition, do not produce sound with your
instrument until the bypass/mute condition
is fully established.
4
3
2
1
CARPARELLI ZE-1 CARPARELLI ZE-1