(j) Slip the new chart under the pen lifter, pen and time index, and press the chart into
place over the chart hub and locating pin.
(k) Grasp the chart hub and locating pin and turn the chart until the desired time line on the
chart is aligned with the time index on the chart plate and Pen #1. Push down the pen
lifter to return the pens to the chart.
(l) Close the recorder door and apply power. The recorder pen will start tracking the input
value, after pen initialization.
ROUTINE MAINTENANCE
The recorder does not require any periodic maintenance. However, the chart and ink cartridges
will have to be replaced as required. The chart paper and ink cartridges can be ordered directly
from Honeywell (USA & CANADA)
Replacement Pen #1 Purple (six pack) PN# 30735489-007
Replacement Pen #2 Red (six pack) PN# 30735489-002
Replacement 10” Chart Paper (25 charts) PN# 30755820-001
Replacing the Ink Cartridge
:
Refer to Figure 8 in the Honeywell manual: Replacing the Ink Cartridge and Chart.
1. Remove power from recorder. Push in the button on the door and swing the door open.
2. Pull up on the pen lifter to raise the pens from the chart plate.
NOTE: DO NOT LIFT THE PENS DIRECTLY
CAUTION
: Be careful not to move the pen arm while removing and installing the ink cartridge.
Note:The longer pen arm is pen #1
3. Unclip and remove the purple (Pen #1) or red (Pen #2) ink cartridge for the pen arm.
4. Remove the protective cap from the pen tip on the new cartridge and open its clip.
5. Slide the new cartridge onto the pen arm so that its tip fits into the notch at the end of
the pen arm and close the clip to secure the cartridge to the pen arm.
6. Push down the pen lifter to return the pen tip to the chart.
7. Close the door and apply power.
Replacing the chart:
Refer to Figure 8 in the Honeywell manual: Replacing the Ink Cartridge and Chart.
1. Remove power from recorder. Push in the button on the door and swing the door open.
2. Pull up on the pen lifter to raise the pens from the chart plate.
NOTE: DO NOT LIFT THE PENS DIRECTLY
3. Lift the chart from the hub and locating pin and slide it from under the pens to remove it
from the chart plate.
4. Slip the new chart under the pen lifter, pens and time index; and press the chart into
place over the chart hub and locating pin.
5. Grasp the chart hub and locating pin and turn the chart until the desired time line on the
chart is aligned with the time index on the chart plate and Pen #1. Push down the lifter to
return the pens to the chart.
6. Close the door and apply power.
Reference: Honeywell DR4300 Circular Chart Recorder GP Model Product Manual
