IS1132A(07/11)
(SIDE 2 OF 2)
R
3)
i)
ii)
Fit handle assembly as follows :
Fit handle (5) directly onto spindle (4).
Screw button (6) onto spindle (4) and tighten firmly against
handle, using plastic key (7) provided.
Important Information
All pipework must be thoroughly flushed prior to
installation.
Turn off hot and cold water supplies before installation.
*
*
Check that threaded nipple (2) is the correct length, as
shown. Cut to length if required ensuring end face is
square. Apply thread tape to the thread.
Place the cover plate (1) over the threaded nipple (2).
Screw the tap body (3) onto the threaded nipple (2) and
position as required. DO NOT OVERTIGHTEN.
2)
1)
Washing Machine Tap Installation
PLUMBERS INSTALLATION INSTRUCTIONS
CIRRUS - LAUNDRY MIXER SET
1 0 m m
Wall/Tile face
Fig. 1
1
2
3
4
7
5
6
G1/2B
Hot and cold water inlet pressures should be equal.
Maximum hot water temperature : 80 C.
IMPORTANT
Pressure & Temperature Requirements.
Static Inlet pressure range : 150 -1000 kPa
New Regulation :-500 kPa maximum static pressure
at any outlet within a building.
(Ref. AS/NZS 3500.1-2003, Clause 3.3.4)