3
www.CarnivalKingSupplies.com
.
gAS CREPE MAKER
General Installation
These appliances are intended for use with Natural Gas or LPG
Regulators used with this appliance must comply with the local standards
Appliances may be converted by qualified personnel. A conversion kit is supplied for
the orifice spud.
•
GAS CONNECTION - The Crepe Maker comes fitted with a 3/4” N.P.T. male adapter for connection to
pressure regulator.
GAS PIPING - Gas piping shall be of such a size and so installed as to provide a supply of gas sufficient
to meet the full gas input of the appliance. If the appliance is to be connected to existing piping, it shall
be checked to determine if it has adequate capacity. Joint compound (pipe dope) shall be used sparingly
and only on the male threads of the pipe joints. Such compounds must be resistant to the action of
LP gases.
MANUAL SHUT OFF VALVES - A manual shut off valve should be installed upstream from the manifold
and within 4 ft of the unit in a position where it can be reached in the event of an emergency.
GAS CONVERSION - Conversion from Propane to Natural Gas or vice versa may only be performed
by the factory or its authorized service agent in the case of troubleshooting, ensure that the correct
orifice sizes of the spuds have been provided.
•
ORIFICE
NATURAL GAS
LP GAS
•
•
•
This appliance should only be used in a WELL VENTILATED ROOM, adequate ventilation allows for the
removal of the products of combustion and allows the entry of replacement air.
This appliance has a factory set primary air intake and no adjustment is necessary. No adjustments
should be undertaken unless carried out by a factory approved agent.
This appliance has a low shelf which can be used as the warming tray.
•
•
•
#44 (2.1mm)
#55 (1.3mm)
