This document contains confidential and proprietary information that remains the property of Carlson Software Inc.
Page 2 of 2
Updated 9/20/2013
Carlson Software Inc.
Carlson Software Inc.
Carlson Software Inc.
Carlson Software Inc.
102 West 2
nd
Street
Maysville, KY 41056
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
Phone: (606) 564-5028
Fax: (606) 564-6422
Setup SurvCE version 2.62 or higher
1) Run SurvCE 2.62 or higher and go into Equip / About SurvCE.
2) In SurvCE from the main menu, choose Equip->GPS Rover.
3) Under the Current tab = set it to Manufacturer: Leica and Model: Viva GS10/GS15 or GS14
4) Tap that the Comms tab and set it to Type: Bluetooth and BT Type: Windows Mobile then tap
the wrenches icon and use the “Find Device” button to add your GPS Rover to the list. Tap
Select then tap the Bluetooth plug icon in the upper right.
5) Tap the RTK tab and set it for Device:
Data Collector Internet
.
6) Tap the tools icon to the right of the device selection. Tap the Connect or Disconnect button
to launch the Internet Connection Manager.
(NOTE: The status here seems to be unreliable.
The safer way to confirm connection is to tap the button and check the Internet Connection
Manager).
7) If it is the first time using the modem, choose
Settings
in the Internet Connection Manager to
setup your APN and connection settings (these will be provided by your network service
provider).
8) To start a connection on the ICM, tap
Start
. Wait up to 3 minutes for connection. When
it is connected, the
Start
button will become a
Stop
button. Choose
Exit
and press NO when
asked if you want to close the connection.
9) The modem is now connected. Press the green check to go back to the RTK tab.
10) For Network, choose NTRIP, and press the tools icon to the right of it. Setup your NTRIP
connection, and choose a base.
11) Back in the RTK tab, set your Solution Type then tap the Green Check to finish the setup.
***Please Note:
You can Exit SurvCE and power off the CS15 and GS15 when your finished.
To reconnect the next day:
1) Power on
JUST
the GS15/GS14 GPS Rover
2) Wait until the Bluetooth light on the GPS Rover is lit up
Green
3)
THEN
turn on the CS15 data collector and wait a few seconds until the Bluetooth light on the data
collector turns
BLUE
4) Double-tap the “Internet Connect” icon and tap “Start” to connect to the Internet
5) Now you can double-tap SurvCE and tap “Connect to Last Bluetooth”
6) When you get to the main menu you can tap Equip / Monitor Skyplot to verify you are getting a
FIXED solution
