CONNECTOR LOCKNUT
Metallic Conduit
NonMetallic Conduit
GROUNDING BUSHING
GROUNDING CONDUCTOR
EQUIPMENT
GROUNDING
TERMINAL
(WHEN PROVIDED)
TA04617 C Page 2 of 4
CAUTION
To prevent enclosure damage and attain the enclosure
requirements, the conduit should be aligned so as to
prevent unnecessary stress on the enclosure walls.
To obtain maximum corrosion protection, with
metallic conduit and hub assemblies, cover (coat)
all exposed metal and seal off the conduit openings
where the conductors enter the enclosures.
Grounding of Equipment:
Install the grounding conductor in accordance with the
requirements of the National Electrical Code. See illustrations
below for metallic and nonmetallic conduit.
Hubs:
For metallic conduit application the use of a Listed Hub and
Grounding Bushing System is required.
For nonmetallic conduit application, use Carlon’s male adapter
(sizes E943 through E943R) and “O” ring (sizes E943DX through
E943RX) with bushing (sizes E943DY through E943RY).
Hinge Caps (included):
Catalog Number CH 100R, have been added to the design
to reduce dirt and dust accumulation in the hinge pin and lid
assembly.
To position the hinge caps, align the snap tang and push.
To remove hinge caps, insert a point (such as a pencil) in the
lid hinge section and push the pencil point toward the side
of the enclosure. This will permit the snap tang to clear the
molded interference. Then pull the hinge cap from the slot.
Figure 3
Figure 4
WARRANTY:
Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to
determine the suitability of this product for the user’s intended application. Thomas & Betts warrants that this product will
be free from defects in materials and workmanship for a period of two (2) years following the date of purchase. Upon prompt
notification of any warranted defect, Thomas & Betts will, at its option, repair or replace the defective product or refund the
purchase price. Proof of purchase is required. Misuse or unauthorized modification of the product voids all warranties.
Limitations and Exclusions:
THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND
IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY
DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST OF REPAIR OR
REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR
ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
© 2017 Thomas & Betts All Rights Reserved.
Thomas & Betts Corporation
Memphis, Tennessee
www.tnb.com
NOTE:
Enclosure drilled for conduit or other fabrication steps may NOT be returned for credit.
EXTERIOR PAINTING OR FINISHING – PLEASE CONTACT THOMAS & BETTS FOR LIST OF
APPROVED FINISHING SYSTEMS.
