5
4.
Mount the EZ connector hardware on the
aileron servo arm.
5.
Find the small aileron pushrod wire.
Make a 90º bend (or a "z" bend, if preferred)
1/4” from the end of the wire
Insert the wire into the control horn.
Secure the wire with a nylon swivel keeper.
6.
Insert the other end of the push rod through
the EZ connector.
Mount your servo arm on top of your servo.
7.
Repeat for the other servo in the other wing
.
Main Landing Gear
2.
Mount the the main landing gear on to the bot-
tom of the fuselage using the 4-40 x 1/2” bolts.
Note:
The flat side of the landing gear goes to the
front.
Caution:Use thread lock on the bolts
1. *
COLLECT THE FOLLOWING PARTS:
(1) Fuselage
(1) Main Landing gear
(3) 4-40 x 1/2 Button Head Bolts
(2) 1/8” Axle with Locking nut
2.
Install both axles on the landing gear.
Installing stabilizer
1. *
COLLECT THE FOLLOWING PARTS:
(1) Fuselage
(1) Stabilizer
(2) Elevator
(1) Wire Elevator Joiner
2.
Mount both wings to the fuselage by inserting
the fiberglass rod into the fuselage and sliding
both wings up tight to the fuselage.
Bolt the wing to the fuselage.
