21
OKAY
These are three 11.1V, 3200mAh batteries. When joined
in Series, the result will be a 33.3V, 3200mAh battery.
❏
2. Connecting batteries in
“Parallel”
means to connect
the +’s to the +’s and the -’s to the -’s. This combines the
batteries’ capacities, but the Voltage remains the same.
NO!!!
NEVER
connect battery packs with different Voltages in
Parallel
–only combine in
Series
. Otherwise, the batteries
will try to “equalize” with the larger one trying to “charge” the
smaller one, thus causing heat and likely a fi re.
NO!!!
Also
NEVER
connect battery packs with different capacities
in Series or in Parallel.
NO!!!
LITHIUM BATTERY HANDLING & USAGE
WARNING!!
Read the entire instruction sheet included with
the battery. Failure to follow all instructions could cause
permanent damage to the battery and its surroundings, and
cause bodily harm!
•
ONLY use a LiPo approved charger.
•
NEVER charge in excess of 4.20V per cell.
•
ONLY charge through the “charge” lead. NEVER
charge through the “discharge” lead.
•
NEVER charge at currents greater than 1C.
•
ALWAYS set charger’s output volts to match
battery volts.
•
ALWAYS charge in a fi reproof location.
•
NEVER trickle charge.
•
NEVER allow battery temperature to exceed
150° F (65° C).
•
NEVER disassemble or modify pack wiring in any
way or puncture cells.
•
NEVER discharge below 3.0V per cell
•
NEVER place on combustible materials or leave
unattended during charge or discharge.
•
ALWAYS KEEP OUT OF REACH OF CHILDREN.
CHECK THE CONTROL DIRECTIONS
1. Turn on the transmitter and receiver and center the
trims. If necessary, remove the servo arms from the servos
and reposition them so they are centered. Reinstall the
screws that hold on the servo arms.
2. With the transmitter and receiver still on, check
all the control surfaces to see if they are centered. If
necessary, adjust the clevises on the pushrods to center
the control surfaces.
FULL
THROTTLE
RUDDER
MOVES
RIGHT
ELEVATOR
MOVES DOWN
RIGHT AILERON
MOVES UP
LEFT AILERON
MOVES DOWN
/
4-CHANNEL RADIO SETUP
(STANDARD MODE 2)
3. Make certain that the control surfaces and the throttle
respond in the correct direction as shown in the diagram.
If any of the controls respond in the wrong direction, use
