11
❏
10. Attach each pushrod to the outermost hole of the
elevator control horns.
❏ ❏
11. Tape or hold the elevator in the neutral position.
Extend the pushrod to the third hole out from the center of
the servo arm. Make a 90° bend at the mark.
❏ ❏
12. Attach a plastic keeper to the pushrod and cut off
the excess portion of the pushrod.
❏
13. Repeat steps 11 and 12 for the other elevator.
RUDDER SERVO & CONTROL INSTALLATION
❏
1. Install the rudder servo in the servo tray.
❏
2. Center the servo and fi t a long, double-sided servo arm
to it.
❏
3. Make a mark 5/8" [16mm] from the bottom of the rudder.
Center a control horn over the mark and drill three holes.
❏
4. Attach two control horns as shown using three (3)
2-56 x 1" [25mm] machine screws and three (3) #2 nuts. Use
threadlocking compound on the screw threads.
❏
5. Trim away the covering from the rudder cable exit
holes in the fuselage. These are located directly below the
elevator servos.
